SSB for Yamaha FJ 1200

This time I made SSB for Yamaha FJ 1200.

It is a bit lonely exterior as it was decided to install and remove the side cover, but it is also possible to install side cover by processing.

I was going to use the engine hanger bolt behind but I could not remove it by any means because it looked like a special bolt and decided to be compact.

画像
画像
画像

And although it is a falling test I think that it was possible to install with a good feeling without grounding the crankcase cover

画像
画像

The exterior is already a vehicle that parts are not out, but how would you say if you want to ride carefully?

http://zrx-drz.at.webry.info/201612/article_1.html

Leave a Reply

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close