SSB crash guards for Kawasaki Z1000 H2

This time, I made SSB for Kawasaki Z-H2.

It was a very easy-to-make vehicle, but I was a little confused about the asymmetrical body and the radiator sub-tank at the very limit of the frame, but I was able to install it without any processing on the body side.
IMG_1049.jpegIMG_1051.jpegIMG_1057.jpegIMG_1059.jpeg

And I passed the fall test safely.
IMG_1063.jpeg
Since the swing arm is sticking out when falling, it feels like the ground is barely touching.
The rear slider seems to be effective when the energy is large.

https://zrx-drz.at.webry.info/202009/article_3.html

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close