SSB for Kawasaki ZX9R

This time I made SSB for Kawasaki ZX9R.

This vehicle is a perfect hanging type frame, where you want to put a bumper
There was no bolt or strength member, invented a new type and made it.

画像
画像
画像

On the frame surface, install it so that the force is dispersed with a thick plate, and the lower side and the back side
In order to catch the receiver on one angle and to give it more strength
Measures were taken by bolting the flat plate adopted at NUDA 900.

We cleared the fall test successfully
It protects both right and left firmly.

画像
画像

I think that the width of the installation was made further by introducing a new type.

http://zrx-drz.at.webry.info/201408/article_1.html

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close