Monthly Archives: January 2023

for Yamaha MT15 This time, I made SSB for MT15. This vehicle has a suspended engine, and there is almost no bolt to attach the lower side of the SSB. At the beginning of production, I was at a loss. Even if I remove the shroud, I can’t find a place where it can be […]

Since the Z900 rear suspension has not been completed, I practiced with the Z250SL for a while. If I don’t run with 900 soon, I’ll forget a lot of things, so I went to a practice session with 900.   I prepared a genuine Z900RS link rod to test various things. If you insert the […]

I went to a practice session with Z250SL for a while during winter training and waiting for 900 rear suspension. In the first place, the handling is sharp, and it is a bit difficult to handle in gymkhana. If we set it up to match Gymkhana, we were able to put out quite good potential […]

I ran the Z250SL for the first time in a while at the Satokana training. Basically, it’s a Z250SL that I often lend to someone, so it’s a bike that I rarely ride all day long. This time, I spent a whole day getting used to the body and running while looking at the direction […]

Satokana training tomorrow. This is the first practice meeting of 2023. I plan to run with the Z900SE this season, but the setup has boiled down to some extent, and I can’t proceed unless the rear suspension I’m working on comes. I think I will run with Z250SL tomorrow. It’s been a long time since […]