Tag Archives: naked

SSB for Honda 2017 Rebel 250 SS

This time I have produced SSB for Honda New Rebel 250. Although it is a slender liability, since it has engines and steps at low places, while making careful attention to the overall height and size, I made while trying not to destroy the design of Rebel as much as possible. I made it well […]

SSB for Suzuki Gixxer 150

This time I made SSB for Suzuki Gixxer 150. Although it was a very new vehicle on the market, the method of installing it neatly and neatly was not thought at first at first though it was refreshing by the method performed by GSXS and MT 10, and it was possible to install without processing […]

SSB & Rear Slider for Kawasaki Z650 2017 model

This time I made SSB and rear slider for Kawasaki’s new Z650. SSB was a vehicle that could be produced with a basic structure. Because it is a framework similar to ER system, it is the same way of stopping at the back side, but it was able to attach more firmly than ever with […]

Sunmeadows practice session

Sanmedo practice session! The weather is good too! Let’s also go touring with the Honda CB 750 (^ ^ ♪ Departing Ome at 4:30am! I ran the mountain pass quickly, I went to Okuri ~ Yamabogi Pass ~ Chichibu, it was much colder than I thought… I didn’t have that light clothes on, but it […]

SSB Compact Crash Bars for Yamaha MT-10 with slider

This time I made SSB Crash guards for the Yamaha MT10. Since there were no easy anchor points, at first I had a feeling that it’ll be a little difficult to design. Additionally since the ECU is inside the fairing it would be a tricky one… But it turned out quite nice and compact on […]

Handle stopper for MT03

Yamaha MT-03 SSB Handle stopper

I made a handle stopper for MT-03/MT-25. It turned out that when you actually tried running it got a bit too steering wheel. I also got information on those already on MT-03, it seems that everyone reduces the steering angle of the steering wheel! So we produced a handle stopper of the type which stops […]

MT03 Gymkhana specification in progress

Yamaha MT-25 / MT-03 [YS17] 2016

I decided to participate in GSXS 1000 this season. We also began developing the gymkhana specification of Yamaha MT-03, a promising vehicle in the middle class. So far we have tuned up front and rear suspension, final sprocket ratio and position matching, aslo ECU re-writing. This are the modifications just for now I am going […]

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close