SSB Crash bars for the New 2017 Honda CBR250RR now under construction

Today when I started I knew it was going to be an exciting and challenging day.
I was producing SSBs crash bar protectors for one of the newest motorcycles out there on the market, the 2017 Honda CBR250RR.

I checked on the internet and knew roughly where the position of the engine hanger was.
But then when I went there to take off the fairing for the first time, in the place where the best spots that you would want to place a bumper, was a  sub-tank of the radiator and on the opposite side there was the regulator…


I planed about various ways to attach it to the main frame and dismissed them over and over again. . .
Even if it is possible to attach it would be terribly difficult for users to install in the future …

But hey, if you attach it a bit more behind, it kind of works….


But then I realized that the image when the cowl is re-attached would not be beautiful at all !
The effect of the bumper also would be likely that the vehicle will tumble forward in event of a fall. . .

Should I just finish the job by attaching it regardless? Or should I pursue the ideal despite the hardships…?

Well… here at the SSB Factory we naturally seek the ideal.

The structure will surely to become complicated, but I now have the idea built up in my head.
I hope to be able to upload the completion of the project tomorrow.

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.